Skip to Content

Rippa Auger on an RS06 Mini Skid Steer: Assembly and First Dig

Unboxing and assembling a Rippa auger and using it on an RS06 mini skid steer, with tips for digging straight, clean holes.

Table of contents

No titles in the blog post

Watch the video: https://www.youtube.com/watch?v=1X1K6yl__pU (6 min)

Mike and Dakota unbox a new Rippa auger (about 12 inches in diameter, 11.87" by 31") and use it on an RS06-1.

ASSEMBLY

  • It comes out of the box ready to go. The auger shaft is held on by a retaining bolt and nut.
  • Grease it, connect the hydraulic lines, make sure everything is tight, start it and check for leaks.

DIGGING TIPS

  • As you go deeper, drive the machine forward slightly to keep the shaft vertical.
  • Every so often raise the auger to clear dirt out of the hole, then lower it again.
  • A cone of dirt about 8 inches wide builds up around the hole. Clear it away or kick it aside, because the plate should be flat on the ground, especially for a 36-inch-deep hole.
  • In this soil (not many rocks) the auger plowed right through, and the RS06 has more power than needed for this size hole.

Questions? Call Rippa USA Sales at 817-382-3201 or visit RippaUSASales.com. We deliver nationwide with flat rate shipping, and you get 50% off attachments when you buy a machine from us.