Skip to Content

Rippa Mini Skid Steer Tiller Attachment: Hookup and Digging Depth

Table of contents

No titles in the blog post

Watch the video: https://www.youtube.com/watch?v=Yfm0zvYT4IE (13 min)

Mike unboxes the Rippa tiller at the Boyd dealership and hooks it up to an RS03 on camera.

HOOKUP

  • Tilt the attachment plate down so you can lock the tiller on, and lock it in.
  • Pull the hydraulic caps and make sure no dust or dirt gets into the hydraulic system.
  • If the motor runs backwards, swap the direction (Mike had to run the machine the other way to get the tines turning correctly).
  • Mike would prefer the motor on top and would weld a small bracket or zip tie to hold the hoses.

DIGGING DEPTH AND STABILITY

  • Measured depth is between 8-1/2 and 9 inches (about 8.75), which suits most users. It will pulverize the ground.
  • When the tiller was lifted on pallet forks it stuck out 2-1/2 to 3 feet farther and was tip-heavy. Mounted on the attachment plate, it is stable even when raised.
  • To rest it fully flat, put a 12x12 or a few 2x4s under each side so the tines don't touch the ground.

FIT

  • This is a Dingo-style attachment that fits the RS03, RS04 and RS06-1.

Part two puts the tiller in the ground once it dries out, along with the trencher.

Questions? Call Rippa USA Sales at 817-382-3201 or visit RippaUSASales.com. We deliver nationwide with flat rate shipping, and you get 50% off attachments when you buy a machine from us.