Skip to Content

Rippa Stump Grinder Attachment: Overview and Hookup

Table of contents

No titles in the blog post

Watch the video: https://www.youtube.com/watch?v=8s6T3iT2AFc (14 min)

Mike walks through the Rippa stump grinder attachment, the only stump grinder we sell. It's a side-to-side swing model, and this video covers how it hooks up and how to run it.

HOOKUP AND SETUP

  • Two hydraulic lines plus an electrical connection.
  • Route the lines through the machine's tie-down points to keep them out of the way.
  • A continuous-flow setting keeps the cutter wheel spinning. It runs in one direction only, so don't use it in reverse.
  • A winch-style controller swings the head side to side.
  • The wheel brake stops the blade in about 1.5 seconds.

CARE AND USE

  • The grinder is greasable, including the swing cylinder. Keep it greased.
  • Lower the head onto the stump and sweep side to side.
  • It weighs roughly 275 to 300 lb, so use caution when moving it.

Questions? Call Rippa USA Sales at 817-382-3201 or visit RippaUSASales.com. We deliver nationwide with flat rate shipping, and you get 50% off attachments when you buy a machine from us.